Back

Quikwedge Standards / Verticals form the support or the uprights and are made from Standard Scaffold Tubes of 48.3 x 4 mm thick. With the latest innovations, they are also available in 48.3 X 3.25 mm in both Grade 50 & 40 C as per BS: 4360. They have a series of "V" Pressed welded at nominal 500 mm on the tube to provide a location for ledger and transoms. They are also available with integral wedge spigots or as open ended.

Back

These items are made from tube with a cast wedge-fixing device at each ends. These are used to lie in the uprights or standards longitudinally. On the inside of the scaffold of the scaffold they are used at platform level and on the outside as a guardrail.

These items are made from tube with a pressed wedge-fixing device at each ends. These used to lie in the uprights or standards longitudinally. On the inside of the scaffold they are used at platform level and on the outside as a guardrail.

They are a rolled "T" section with wedge fixing device on each ends. Also available with back to back angles of 50 x 50 x 5mm to form a "T" These transoms engaged with "V" pressing on the Standard/Verticals fixing the inner and outer standards transversely and forming a frame.

Manufactured from a steel pressing shaped so that it can be placed over a Ledger to form a 90% return in the scaffold, the Return Transom has a seating on one side for Steelstage or Timber Battens.

One Board Stage Bracket enables an additional 255 mm platform to be provided on the inside of the scaffold. They do not require Tie Bars to connect them together. Available with rolled "T" Section or back to back welded angles.

The Two and Three Board Stage Brackets enable an additional 450 mm (1’6") and 675mm (2’3") platform respectively to be provided on the inside of the scaffold nearest the building. Tie Bars must be used to connect the brackets together. They are available in both rolled section and back to back welded angle.

A length of 38 mm x 38 mm angle iron with a dowl at both ends. Used to connect stage brackets together.

Diagonal Brace has pivoting captive wedge fittings welded to each end, which locate the "V" pressing on the standards. Used to form facade bracing.

A Cantilever transom similar to the stage bracket with integral guard rail standard to take a ledger. This component is used where a platform is required on the outside of the scaffold with steel or timber battens makes a platform of 0.686 m wide and available in both rolled section and back to back angles.

When clamped to standards at the end of the scaffold platform, the End Toe Board Bracket secures the end toe board, which can be either Steelstage or timber.

They are long live pressed steel battens with steel battens as part of the Quikwedge System.